The All Round Guide To Excavator Wear Parts (Part One)

On an excavation machine, the bucket is made out of solid steel. Attachments on the bucket, are important for having the ability to disrupt hard material and helping to avoid the general wear and tear of the excavator bucket.

One way of maximising the life of the buckets is to replace the wear parts which is a small cost in comparison to having to buy a new one. Having a broken or ineffective machine will be no use to you or your business, and if something like the bucket is damaged you will have mulcherparts to dig deep into your pockets in order to get it repaired. This means that keeping on top of these small maintenance jobs is imperative if you want to avoid a big pay out, and in this economic adversity this is a fee that most businesses simply cannot afford. These winter months where your excavator machine is likely to not be in use as much, could be a great time to conduct these necessary checks. Here is exactly what you should be inspecting:

Find out which wear parts are damaged by carrying out a visual inspection. For instance on your bucket teeth, have a look to see if any of the teeth appear to be dulled or worn which will have occurred from over-exposure. You should also check to see if the metal has been sheared in any way which may happen when too much force is exerted on them.

When replacing the edges keep in mind that they are normally fitted on with bolt-on wear blades. Equally this is the case with the bucket teeth as they are generally either bolted or welded on. Depending on how it has been fitted will decide how it is removed. If you find the wear part has been installed with a bolt, you will be able to remove it with the appropriate sized wrench. On the other hand if it has been welded on you will need to use a cutting torch. In some cases even if the part was originally bolted on it may have been sheared or mangled which means that it could need to be removed using a cutting torch.

If you do not maintain your machine it could be the worst thing you could do, especially when it comes to an important job, as you do not want your machine to fail you. This is because downtime will equal a loss of money which is something that can be avoided.

 

Article Source: http://EzineArticles.com/8325383

Leave a Reply

Your email address will not be published. Required fields are marked *